Braam

A massive brassy synth blast with a growling detuned saw stack, built for trailer hits

one-shot · 3.74 s · 0 downloads · 0 likes

0.00 / 3.74 sMP3 preview · default

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get GMPQ482TC1@1 -o braam.wav

Source: a brass-section blast imitated with analog-style synthesis: seven band-limited saws spread ±(6–30) cents around a low root (≈ 43 Hz) plus a second stack an octave up, a sine sub an octave below, and breath noise.
Body: a brass "blat": a low-pass whose cutoff swells from ≈ 220 Hz to 1.4–5 kHz in 0.28 s as the lips open, then relaxes to a darker sustain; a peak near 520 Hz gives the horn-bell colour; tanh saturation adds the distorted growl, followed by a gentle low-pass so harmonics stay below alias range.
Envelope: 60 ms attack, a hard peak, a 0.5 s settle to the sustain, a long held body and a curved release that lets the low end fade; a 5 Hz pitch wobble grows into the sustain like a tiring embouchure.
Variation: `rng` offsets each saw's detune, phase and drift slightly; presets change root pitch, grit, brightness and length (trailer hit, dark horn, snarling, short stab).

Parameters
Parameter	Range	Default	Unit	Controls
length	1.5 – 5	3.6	s	Length
pitch	32 – 70	43.65	Hz	Root pitch
brightness	0 – 1	0.55	—	Brightness
grit	0 – 1	0.5	—	Growl
detune	0 – 1	0.5	—	Detune
sub	0 – 1	0.6	—	Sub
breath	0 – 1	0.3	—	Breath
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1