Clothone-shot · 1.50 s
♥ 0↓ 0@sonicbricks
Cotton Fabric Rip
A dry cotton tear with stuttering bundles of breaking threads, bright fibre rasp and a soft release.
one-shot · 1.00 s · 0 downloads · 0 likes
0.00 / 1.00 sdefault
Tweak
renders in the CLI · WAVChange parameters to build an exact command. Your agent runs it with sb and gets the WAV.
$ sb get JNBWY870GN@1 -o cotton-fabric-rip.wav
How it's made
- Source
- tension breaks successive cotton yarns. Irregular 1–3 ms noise attacks decay over 6–22 ms; 50–120 overlapping yarn failures per second form a rough rip rather than isolated impact clicks.
- Body
- cotton is highly damped, with broad friction bands at 0.5–1.5 and 2–6 kHz, not ringing modes. A quieter pink-noise layer follows the pulling hand; a low-pass at 6–9 kHz softens exposed fibres.
- Envelope
- a 35 ms tension onset leads into an accelerating 0.44–0.98 s tear. Uneven bundles interrupt the pull, then the final yarns release into 65 ms of soft cloth movement. No room tail is added.
- Layers
- overlapping filtered noise grains provide thread detail; a dense filtered impulse texture adds microscopic fibre roughness beneath them. All layers share the changing bundle pressure.
- Variation
- seeded timing, bandwidth, grain duration and strength vary each yarn. Speed changes length; weave changes grain density and low-mid body, brightness changes friction colour, snag adds pauses.
- Presets
- a brisk narrow strip, a thick cotton tear, a hesitant snagged pull and a light worn sheet.
| Parameter | Range | Default | Unit | Controls |
|---|---|---|---|---|
| speed | 0 – 1 | 0.38 | — | Pull speed |
| weave | 0 – 1 | 0.55 | — | Weave weight |
| brightness | 0 – 1 | 0.65 | — | Fibre brightness |
| snag | 0 – 1 | 0.45 | — | Bundle hesitation |
| seed | int | 1 | — | Variation, reproducible |
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.
Revision history1
- r12026-10-25engine 1.0.1use('JNBWY870GN@1')