Woodloop · 8.00 s
♥ 0↓ 1@sonicbricks
Handsaw Cutting Wood
Steady push-pull handsaw strokes with toothy rising rasp and dry wooden board resonance.
loop · 6.00 s · 0 downloads · 0 likes
0.00 / 6.00 sdefault
Tweak
renders in the CLI · WAVChange parameters to build an exact command. Your agent runs it with sb and gets the WAV.
$ sb get E55F68CEGF@1 -o handsaw-cutting-wood.wav
How it's made
- Source
- steel teeth scrape wood fibres; band-limited noise is modulated by irregular tooth contact. Tooth repetition rises from 85-180 Hz to 210-430 Hz within each stroke, under a broad friction band.
- Body
- a supported board colours friction at 240, 630 and 1370 Hz with broad, heavily damped modes; a quiet blade band rises through 1.7-3.5 kHz, without a sustained metallic whistle.
- Envelope
- 5-10 push-pull cycles per 6 s. Each stroke has a 22 ms engagement, a loaded middle and 45 ms release; lighter return strokes alternate with loaded cutting strokes. No impact at reversal.
- Layers
- modulated tooth rasp, diffuse fibre friction and low board vibration remain dry and centred.
- Variation
- seeded contact roughness, per-stroke tuning within 3 percent and pressure within 8 percent. Presets cover normal crosscutting, slow coarse teeth, delicate fine teeth and fast short strokes.
- Loop
- the 6 s render contains an integer number of full push-pull cycles, ending at a reversal gap.
| Parameter | Range | Default | Unit | Controls |
|---|---|---|---|---|
| cycles | 5 – 10 | 7 | — | Push-pull cycles |
| teeth | 0 – 1 | 0.5 | — | Tooth fineness |
| load | 0 – 1 | 0.6 | — | Cutting pressure |
| board | 0 – 1 | 0.5 | — | Board thickness |
| seed | int | 1 | — | Variation, reproducible |
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.
Revision history1
- r12026-10-25engine 1.0.1use('E55F68CEGF@1')