Modal Open Bloom

A soft airy bloom with a gentle tonal glint as a dialog or sheet appears over the page

one-shot · 0.43 s · 0 downloads · 0 likes

0.00 / 0.43 sMP3 preview · default

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get QKW5T21S8P@1 -o modal-open-bloom.wav

Source: air pushed gently as a panel rises into view: decorrelated pink noise in left and right channels, high-passed at 250 Hz so there is no rumble.
Body: a wide band-pass (Q ≈ 0.7) whose centre opens upward from about 700 Hz to 2.5-5 kHz while the panel settles, giving the "bloom"; a second, narrower band follows it slightly higher for a touch of breath.
Glint: one soft tonal sparkle, a sine with a quieter inharmonic partial (ratio ≈ 2.4), starting just after the swell begins and ringing out in the tail, never sharp.
Envelope: smooth fade-in over about 55 % of the length (curved), a short release; the glint has a 6 ms ramp.
Variation: `rng` detunes the glint by ±2 % and shifts the swell peak by a few percent.

Parameters
Parameter	Range	Default	Unit	Controls
length	0.25 – 0.7	0.33	s	Length
brightness	0 – 1	0.5	—	Brightness
air	0 – 1	0.6	—	Air
glint	0 – 1	0.5	—	Glint
pitch	1000 – 3000	1760	Hz	Glint pitch
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1