Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get ESTTJ02FSH@1 -o upward-arpeggio-flourish.wav
How it's made
Source
a polysynth voice playing a fast ascending arpeggio. Each note is two band-limited saws detuned by ±6 cents (analog-style chorus) plus a sine one octave up for shimmer; no sample-and-hold, no noise.
Body
a resonant low-pass per note whose cutoff sweeps from about 5× down to 1.5× the note frequency in roughly 0.18 s, the classic "pluck" spectral movement: bright attack, mellow body. Q stays below 2 so nothing rings harshly.
Envelope
a 3 ms attack avoids clicks, then an exponential decay of 0.15–0.5 s per note. Notes are 55–90 ms apart so they overlap into one rising gesture, and each note is slightly louder than the last.
Echo
three feedback-style taps at one, two and three delay times (about 0.2 s), each −9 dB quieter and darker (low-pass 7 kHz, 4.5 kHz, 3 kHz), like a tape echo; the final envelope closes the tail at about 1.2 s.
Variation
`rng` detunes each note by a few cents and jitters its timing by ±2 ms. The scale (major, minor, lydian), root, note count and spacing change the arpeggio; notes pan gently left to right.
Parameters
Parameter
Range
Default
Unit
Controls
root
220 – 660
440
Hz
Root
scale
major · minor · lydian
major
—
Scale
notes
4 – 8
6
—
Notes
spacing
0.045 – 0.1
0.065
s
Spacing
brightness
0 – 1
0.6
—
Brightness
decay
0.12 – 0.5
0.25
s
Note decay
echo
0 – 1
0.5
—
Echo
echoTime
0.12 – 0.28
0.2
s
Echo time
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.