Raintexture · 10 s
♥ 0↓ 0@sonicbricks
After Rain Drips
Slow eave and leaf-tip drips, rounded puddle plinks and quiet outdoor air after the rain stops
texture · 15 s · 0 downloads · 0 likes
0.00 / 15 sLeaf tips
Tweak
renders in the CLI · WAVChange parameters to build an exact command. Your agent runs it with sb and gets the WAV.
$ sb get B7193TZD47@1 --preset leaf-tips -o after-rain-drips.wav
How it's made
- Source
- retained rainwater detaches from two eaves and scattered leaf tips, not falling rain. Eaves recur every 1.4-8 s with 24 percent jitter; leaves add 0.04-0.35 irregular drops/s.
- Body
- puddle impacts trap 1.3-4.8 mm air bubbles, giving roughly 0.7-2.5 kHz rising plinks. A smaller satellite bubble sometimes follows 9-22 ms later; no enclosed-space reverberation.
- Transient
- 0.8-1.8 ms rounded attacks excite 6-22 ms splashes, filtered to 650 Hz-6 kHz. Drops caught on leaves instead make soft 1-3 kHz taps with 20-55 ms damped wet flutter.
- Envelope
- bubble damping supplies the short tonal tail; each voice fades out by 420 ms. Decorrelated air at 180 Hz-2.8 kHz drifts over several seconds well below individual drips.
- Variation
- independent seeded timing, radius, strength, splash cutoff and stereo placement. Presets distinguish steady eaves, leaf-tip scatter, large puddle drops and the final sparse drips.
| Parameter | Range | Default | Unit | Controls |
|---|---|---|---|---|
| pace | 0.15 – 0.7 | 0.42 | drops/s | Eave pace |
| leaves | 0 – 1 | 0.4 | — | Leaf scatter |
| size | 0 – 1 | 0.45 | — | Puddle drop size |
| puddle | 0 – 1 | 0.7 | — | Puddle landings |
| air | 0 – 1 | 0.35 | — | Quiet air |
| seed | int | 1 | — | Variation, reproducible |
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.
Revision history1
- r12026-10-24engine 1.0.1use('B7193TZD47@1')