Barefoot on Wet Tile

How it's made

Source

bare heel pads compress against a wet tile, followed by the broad forefoot 26-74 ms later. Filtered noise with 4-8 ms attacks models compliant flesh, without a hard impact click.

Body

broad 110-450 Hz pressure and 550-1800 Hz flesh deformation dominate. A much quieter 1.7/2.9 kHz pair of low-Q bands suggests rigid tile loaded and damped by skin, not a ringing plate.

Layers

centered heel pressure, a stronger spreading sole smack, then water squeezed out of the contact patch. The thin-film turbulence darkens from 2.6-4.2 kHz to 850 Hz over 110-180 ms; a weak irregular 700-1400 Hz residue follows the forefoot, without a puddle spray or bubble plop.

Envelope

heel rises in 6 ms and fades in 65-105 ms; sole attack is 4-8 ms with 80-125 ms release. Film squeeze peaks 10-20 ms after the sole and vanishes by 270 ms. Final fade reaches zero at 300 ms, leaving a clean tail in a roughly 400 ms file. No baked-in room reverb.

Variation

seeded noise, band tuning +/-7 percent, contact gap and heel/sole balance vary per instance. Weight shifts pressure balance, moisture controls squeeze duration and level, and roll controls heel-to-sole timing. Presets are a cautious toe-led step, ordinary wet walk, heavy flat-foot smack and a slow water-rich roll; all retain soft skin contact.

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.