UIloop · 4.00 s
♥ 0↓ 0@sonicbricks
Button Release
The subtle, light return click of a held button being released, softer and slightly higher than a press
one-shot · 0.16 s · 0 downloads · 0 likes
0.00 / 0.16 sMuted
Preset
Tweak
renders in the CLI · WAVChange parameters to build an exact command. Your agent runs it with sb and gets the WAV.
$ sb get 46S417X1P5@1 --preset muted -o button-release.wav
How it's made
- Source
- a fingertip lifting off a small plastic button. The return is gentler than the press: the spring pushes the cap up against its stop with a soft 1.5–4 ms low-passed noise contact, then a tiny latch tick follows about 3–6 ms later as the stem seats.
- Body
- the key cap rings in two lightly damped modes (about 2.4–4.2 kHz, ratio ≈ 2.2), a little higher than the press because less mass is loaded on it; the housing adds a small, short "tup" at 300–600 Hz with far less weight than the press thock.
- Envelope
- attack under 0.5 ms; the cap modes fade 60 dB in 15–50 ms, the housing tup in about 15 ms; the whole event is over in roughly 0.1 s and nothing sustains.
- Variation
- `rng` mistunes the modes by ±3 % and shifts the latch delay slightly, so repeated releases differ. Brightness opens the contact filter, body scales the housing tup, latch scales the seating tick; presets trade these for soft, crisp, mechanical and muted switches.
| Parameter | Range | Default | Unit | Controls |
|---|---|---|---|---|
| brightness | 0 – 1 | 0.45 | — | Brightness |
| body | 0 – 1 | 0.3 | — | Body |
| decay | 0.012 – 0.05 | 0.03 | s | Time for the cap modes to fade 60 dB |
| latch | 0 – 1 | 0.4 | — | Level of the small seating tick after the contact |
| pitch | 2000 – 4200 | 3000 | Hz | Cap pitch |
| seed | int | 1 | — | Variation, reproducible |
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.
Revision history1
- r12026-10-24engine 1.0.1use('46S417X1P5@1')