Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get 9EFWFF3SBJ@1 --preset plastic -o card-flip.wav
How it's made
Source
a stiff card turning over in the fingers. Air squeezed past the edge is a short burst of pink noise; at the turning point the card flexes and snaps flat, a 1–3 ms broadband tick from the paper fibres.
Body
the flutter is band-passed noise (Q ≈ 1.4) whose centre rises 1.2 → 4.5 kHz as the card speeds up, then falls as it slows. The snap excites two damped paper modes (≈ 2.6 kHz and ≈ 1.9 × that, 15–30 ms) and a soft low "pat" (300–380 Hz, 25 ms) from the card landing on its back.
Envelope
flutter swells over ~60 ms with a fast 28–40 Hz flap ripple in the level that dies out; the snap lands at about 55 % of the length; everything is over within ~0.2 s.
Variation
`rng` shifts the snap time by ±4 %, mistunes the paper modes ±3 % and varies the flap phase, so repeated flips differ slightly. Stiffness moves the mode pitch, snap sets the click level.
Parameters
Parameter
Range
Default
Unit
Controls
speed
0 – 1
0.5
—
Speed
snap
0 – 1
0.6
—
Snap
flutter
0 – 1
0.6
—
Flutter
brightness
0 – 1
0.5
—
Brightness
stiffness
1600 – 4200
2600
Hz
Card stiffness
direction
-1 – 1
0
—
Stereo travel of the flip
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.