Cordless Power Drill

A cordless drill drives a screw with a rising motor whine, loaded gear chatter and a braked stop.

one-shot · 2.18 s · 0 downloads · 0 likes

0.00 / 2.18 sMP3 preview · Slow high torque

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get EM9JDN0AJ4@1 --preset high-torque -o cordless-power-drill.wav

Source: a cordless drill driving a screw; rotor hum at 130–290 Hz and gear mesh at 0.9–2.3 kHz. Rounded harmonics, speed-linked brush noise and fan turbulence form separate continuous layers.
Body: broad plastic housing bands at 460 and 1850 Hz colour the noise; no room reverb is baked in.
Envelope: 0.16–0.40 s trigger ramp, screw resistance lowers speed through the drive, then an electric brake stops rotation in 90 ms. The complete action lasts about 2 s, including a short silent tail.
Events: jittered 55–95 Hz tooth chatter grows under load; 5–8 late clutch slips use 3 ms excitation into 650/1450/3100 Hz damped modes, lasting 16–35 ms, before the trigger releases.
Modulation: 2.6 Hz speed wander and rotor-rate torque ripple couple whine and noise to the drive.
Variation: seeded tuning, chatter strength and slip timing; speed, load, trigger ramp, drive time and clutch amount distinguish fast light screws, slow torque, clutch seating and gentle trigger control.

Parameters
Parameter	Range	Default	Unit	Controls
speed	0 – 1	0.62	—	Motor speed
load	0 – 1	0.6	—	Screw resistance
ramp	0.16 – 0.4	0.28	s	Trigger ramp
drive	1.35 – 2.05	1.7	s	Drive time
clutch	0 – 1	0.45	—	Clutch slip
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1