Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get 1TEX86TN1Q@1 --preset wooden -o drawer-slide.wav
How it's made
Source
a panel gliding on its runners and then meeting a stop. Sliding friction is turbulent, rough contact noise (pink noise); the stop is a short soft contact tick plus a low thump of the frame.
Body
the runner contact band-passes the noise (Q ≈ 1.1) between 700 Hz and 2.9 kHz, and the panel adds a faint resonance (about 440 Hz, Q 8) that glides down a few percent as the panel slows. The frame rings in two damped modes (about 100-170 Hz and 2.5x that, 35-100 ms) when the panel stops.
Envelope
friction swells in 40 ms, peaks near 35 % of the travel and fades as the panel decelerates; the stop lands at 0.17-0.22 s with a 1 ms contact and a thump that decays in about 70 ms.
Variation
`rng` shifts the stop time and mode tuning by a few percent; speed shortens the slide and raises the friction pitch, weight lowers the thump, and roughness adds grain to the friction.
Parameters
Parameter
Range
Default
Unit
Controls
speed
0 – 1
0.5
—
Speed
weight
0 – 1
0.5
—
Weight
roughness
0 – 1
0.4
—
Roughness
stop
0 – 1
0.6
—
Stop click
side
-1 – 1
0
—
Negative values sit left, positive right
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.