Firetexture · 15 s
♥ 0↓ 1@sonicbricks
Flamethrower Burst
An explosive ignition opens a rolling fuel-flame roar and broadband jet, tapering into a soft flame wash.
one-shot · 2.30 s · 0 downloads · 0 likes
0.00 / 2.30 sFocused pressure jet
Tweak
renders in the CLI · WAVChange parameters to build an exact command. Your agent runs it with sb and gets the WAV.
$ sb get E1YBJT80W2@1 --preset needle -o flamethrower-burst.wav
How it's made
- Source
- pressurized burning fuel entrains air; pink and white noise model the broadband turbulent jet. A separate 6 ms ignition front blooms into a 180 ms low-mid pressure burst, not a hard digital click.
- Body
- broad, damped noise bands at 120-450 Hz represent combustion eddies, not a pitched motor. The jet spans 140 Hz to 3-7 kHz; its upper cutoff collapses toward 850 Hz as pressure dies away.
- Envelope
- ignition overshoot settles by 180 ms; the default burn rolls for 1.5 s, then tapers to 2.4 s. High-frequency spray dies first; the low flame wash trails behind. No room reverb is baked in.
- Modulation
- independent 9-24 Hz random eddies roughen amplitude and cutoff; irregular 12-40 ms fuel pockets add soft, band-limited combustion flutters rather than wood crackles or sparks.
- Variation
- seeded eddies, pocket timing, strength and pan change each render; the core stays centered. Presets vary burn duration, jet brightness, flame weight, sputter depth and stereo spread.
| Parameter | Range | Default | Unit | Controls |
|---|---|---|---|---|
| length | 1.4 – 2.9 | 2.4 | s | Burn length |
| heat | 0 – 1 | 0.6 | — | Jet brightness |
| weight | 0 – 1 | 0.6 | — | Flame weight |
| sputter | 0 – 1 | 0.45 | — | Fuel turbulence |
| spread | 0 – 1 | 0.35 | — | Flame spread |
| seed | int | 1 | — | Variation, reproducible |
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.
Revision history1
- r12026-10-24engine 1.0.1use('E1YBJT80W2@1')