Marimba Notify

A warm two-note wooden mallet notification with a soft attack and a round decay

one-shot · 0.65 s · 0 downloads · 0 likes

0.00 / 0.65 sMP3 preview · Bright

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get G0W9HZYJC4@1 --preset bright -o marimba-notify.wav

Source: a soft yarn mallet striking two successive rosewood marimba bars. The contact is a 3–8 ms low-passed noise thump; a softer mallet is longer and darker, a harder one adds click and upper partials.
Body: a tuned bar rings at its fundamental plus the characteristic tuned overtones (≈ 3.9× and ≈ 9.2×). The upper partials fall away much faster than the fundamental (0.12×, 0.05× of the ring time), so the bright strike settles into a round, almost pure tone. A resonator tube below the bar re-emphasises the fundamental and gives the woody "oo" bloom.
Envelope: 1.5 ms soft attack, exponential decay of 0.2–0.9 s per note; the second note starts 0.12–0.35 s later while the first is still ringing, then everything fades out by about 0.9 s.
Variation: `rng` detunes each partial by a fraction of a percent and varies note strength, so repeated renders are not machine-identical.

Parameters
Parameter	Range	Default	Unit	Controls
pitch	330 – 880	523	Hz	Pitch
interval	major-third · fourth · fifth · major-sixth	fifth	—	Interval
spacing	0.12 – 0.35	0.2	s	Spacing
ring	0.2 – 0.9	0.45	s	Ring
mallet	0 – 1	0.35	—	Mallet hardness
body	0 – 1	0.5	—	Resonator body
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1