UIloop · 4.00 s
♥ 0↓ 0@sonicbricks
Message Send
A quick rising whoosh with an airy tail and a bright tonal flick, for a message leaving the outbox
one-shot · 0.35 s · 0 downloads · 0 likes
0.00 / 0.35 sSnappy
Tweak
renders in the CLI · WAVChange parameters to build an exact command. Your agent runs it with sb and gets the WAV.
$ sb get 4ZA5MFGZHV@1 --preset snappy -o message-send.wav
How it's made
- Source
- a message leaving an outbox, heard as air rushing past (pink noise, high-passed at 300 Hz) plus a small bright tonal flick as it clears the edge (two sine notes with a stretched inharmonic partial).
- Body
- the air layer goes through a band-pass (Q ≈ 1.4) whose centre rises quickly from ~500 Hz to 3.5–7.5 kHz over the first 90 ms; the flick notes ring like a tiny glass bell, partial ratio ≈ 2.76.
- Envelope
- whoosh swells over ≈ 90 ms and releases into an airy 60–250 ms tail; the flick notes start 70 ms and 105 ms in (a rising interval), 2 ms onset ramp, 70–110 ms decay; the whole sound ends by about 0.35 s.
- Variation
- `rng` detunes the notes by ±1.5 %, shifts the whoosh peak by a few percent and decorrelates the left and right air streams; presets change tail, brightness, interval and flick weight.
| Parameter | Range | Default | Unit | Controls |
|---|---|---|---|---|
| brightness | 0 – 1 | 0.55 | — | Brightness |
| air | 0 – 1 | 0.5 | — | Air |
| flick | 0 – 1 | 0.55 | — | Flick |
| tail | 0.06 – 0.25 | 0.15 | s | Length of the airy release |
| pitch | 1200 – 2600 | 1760 | Hz | Flick pitch |
| interval | 1.2 – 2 | 1.5 | — | Frequency ratio of the second note |
| seed | int | 1 | — | Variation, reproducible |
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.
Revision history1
- r12026-10-24engine 1.0.1use('4ZA5MFGZHV@1')