Microwave Running

Steady microwave operation with electrical hum, cooling-fan whir and slow glass-turntable rumble.

loop · 8.00 s · 0 downloads · 0 likes

0.00 / 8.00 sMP3 preview · Beside the cooling vent

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get G6PQRB5CA0@1 --preset side-vent -o microwave-running.wav

Source: a running microwave: transformer vibration at 50/60 Hz and dominant 100/120 Hz harmonics, cooling-fan turbulence, blade passage, and the loaded glass turntable rolling on its support ring.
Body: the sheet-metal enclosure colours airflow at 430 and 920 Hz with broad, damped resonances; transformer partials fall rapidly above 600 Hz. Roller friction occupies roughly 65–420 Hz.
Envelope: continuous operation, without switching, beeps or door sounds. An 8 s revolution gently modulates roller pressure; three support rollers add a softer 0.375 Hz undulation, never impacts.
Modulation: fan blades pass at 240–360 Hz with 0.25 Hz pitch flutter below 0.3 percent and gentle 0.5 Hz air flutter. Vent colour breathes by 3 percent over 8 s; no exaggerated wind gusts.
Variation: seeded independent air and bearing noise, plus seeded cyclic phases. Mains is 50 or 60 Hz; fan, hum, platter load and vent openness set source balance, spectral tilt and blade speed.
Presets: compact fan-led 60 Hz, transformer-led 50 Hz, exposed bright side vent, and loaded platter. Sources stay close and nearly mono; no room reverb. Periodic layers complete whole cycles in 8 s.

Parameters
Parameter	Range	Default	Unit	Controls
mains	50 · 60	60	—	Mains frequency
hum	0 – 1	0.55	—	Transformer hum
fan	0 – 1	0.6	—	Cooling fan
platter	0 – 1	0.4	—	Turntable load
vent	0 – 1	0.45	—	Vent openness
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1