Stonetexture · 15 s
♥ 0↓ 0@sonicbricks
Pebble Drop
A pebble clicks against bare rock, then settles through softer, accelerating bounce ticks.
one-shot · 0.38 s · 0 downloads · 0 likes
0.00 / 0.38 sLow skitter
Tweak
renders in the CLI · WAVChange parameters to build an exact command. Your agent runs it with sb and gets the WAV.
$ sb get BB5JH7KG4V@1 --preset skitter -o pebble-drop.wav
How it's made
- Source
- a small solid pebble hits bare rock; a 1.4-3.6 ms band-limited noise contact makes the click.
- Body
- twelve irregular solid modes span about 0.8-8 kHz, with 18-65 ms T60; upper modes die first. A broad 350-950 Hz surface response adds weight without a hollow cavity or a pitched metallic ring.
- Envelope
- 2-6 contacts lose amplitude geometrically. Flight intervals shrink by 0.62 after each rebound; weaker impacts have less high-frequency energy and shorter body decays.
- Layers
- a quiet 9-18 ms filtered grit burst follows each contact as the rough surfaces slip. The response is dry and centred, with sub-bass removed and a silent release before the render ends.
- Variation
- seeded contact noise, mode tuning (+/- 3 percent), timing (+/- 4 percent), and impact level. Size changes mode frequencies and weight; hardness changes contact bandwidth and damping.
- Presets
- small sharp chips, round muted pebbles, heavier stones, and low-height skittering rebounds.
| Parameter | Range | Default | Unit | Controls |
|---|---|---|---|---|
| size | 0 – 1 | 0.45 | — | Pebble size |
| hardness | 0 – 1 | 0.65 | — | Contact hardness |
| contacts | 2 – 6 | 5 | — | Contacts |
| flight | 0.09 – 0.19 | 0.17 | s | First rebound time |
| retention | 0.42 – 0.7 | 0.58 | — | Rebound strength |
| seed | int | 1 | — | Variation, reproducible |
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.
Revision history1
- r12026-10-25engine 1.0.1use('BB5JH7KG4V@1')