Reverse Reverb Suck

A reversed reverb tail swelling into a sudden cutoff; the breath before a hard cut or a hit

one-shot · 2.11 s · 0 downloads · 0 likes

0.00 / 2.11 sMP3 preview · Cathedral inhale

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get SA69CFD36S@1 --preset cathedral -o reverse-reverb-suck.wav

Source: the tail of a large diffuse reverb played backwards. Two decorrelated pink-noise beds (left and right) stand for the dense reflections; a soft band of sustained partials stands for the pitched ring of the room.
Body: in a forward reverb the highs die first, so reversed they arrive last: the wash starts dark and muffled (low-pass near 350 Hz) and opens up to a bright, airy hiss while a band-pass "suck" sweeps upward. A thin detuned partial stack glides up a fifth-ish interval, giving the pull towards the cut.
Envelope: an exponential swell (a reversed 60 dB decay) that is slow at first and accelerates, reaching its peak at the very end; then a hard cut, softened only by a 3 ms fade so it stays click-free. A soft transient "air push" is deliberately absent: the sound ends exactly where the hit would begin.
Variation: length, brightness, tone (tonal ring amount), width, and rng-shifted partial detune.

Parameters
Parameter	Range	Default	Unit	Controls
length	0.4 – 2.5	1	s	Length
brightness	0 – 1	0.55	—	Brightness
tone	0 – 1	0.35	—	Tonal ring
width	0 – 2	1.2	—	Width
pull	0 – 1	0.5	—	Pull
pitch	80 – 800	220	Hz	Ring pitch
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1