Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get 67X5QPDEDY@1 --preset high-pressure -o shower-running.wav
How it's made
Source
pressurized jets break into droplets; independent stereo noise forms a 0.7–9 kHz spray bed. A softer 180–1800 Hz pink layer represents water sheeting over the wet tiled floor.
Body
tiles scatter impacts rather than ring like metal; broad 1.6–6.5 kHz splash bands have Q 0.6–1.2.
Events
45–150 splashes/s, with 0.7–1.8 ms attacks and 12–42 ms decays, merge into fine wet grain.
Envelope
a steady 10 s loop; independent 0.3–1.4 Hz drift changes level by only 4–10 percent and gently moves the spray cutoff. There is no valve opening, closing, or periodic pumping.
Space
13/21/34 ms early reflections and a damped short room tail represent a small tiled bathroom.
Variation
seeded streams vary splash timing, strength, frequency, envelope and stereo placement. Pressure changes spray bandwidth and impact density; floor splash, room and distance change perspective.
Presets
soft overhead rain, forceful jets, close floor splatter, and a more reverberant shower stall.
Parameters
Parameter
Range
Default
Unit
Controls
pressure
0 – 1
0.6
—
Water pressure
splatter
0 – 1
0.55
—
Floor splatter
room
0 – 1
0.4
—
Room reflections
distance
0 – 1
0.2
—
Listening distance
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.