Slide-In Snap

A quick dry swipe that ends in a tight snap, for motion-graphics elements sliding into place

one-shot · 0.58 s · 0 downloads · 0 likes

0.00 / 0.58 sMP3 preview · default

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get XW48SVNC3C@1 -o slide-in-snap.wav

Source: a fast swipe is air rushing past, pink noise high-passed at 200 Hz; the end is a hard stop, a tiny dry transient (high-passed white noise burst) over a short wooden-tick body and a soft low thump.
Body: the swipe band-pass (Q ≈ 1.4) rises quickly from 400 Hz to a bright peak right before the stop; the snap body is a band-pass noise tick around 2.4 kHz plus a damped sine at 190 Hz falling to 110 Hz.
Envelope: the swipe swells on an accelerating curve (exponent 2.2), peaks just before the snap and drops in about 12 ms so it never clicks; the snap attacks in 0.3 ms, the tick lasts ~25 ms and the thump ~90 ms.
Variation: swipe length, brightness, snap hardness, thump weight and travel direction; `rng` nudges the snap time and tick pitch by a few percent.

Parameters
Parameter	Range	Default	Unit	Controls
length	0.15 – 0.7	0.36	s	Swipe length
brightness	0 – 1	0.5	—	Brightness
snap	0 – 1	0.6	—	Snap hardness
weight	0 – 1	0.4	—	Thump weight
travel	-1 – 1	0.6	—	Negative values travel right to left
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1