Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get C08WH3BS4M@1 --preset dome -o soft-tap-click.wav
How it's made
Source
a fingertip pressing a padded, rubber-domed touch button. Soft flesh spreads the contact over 3–6 ms, so the strike is a low-passed noise burst (cutoff 0.9–3 kHz) with no hard edge.
Body
the dome and its housing are heavily damped. Three low-mid modes (≈ 1 : 1.9 : 3.1 around 280–600 Hz) decay 60 dB in only 12–45 ms, so the sound has weight but never rings; a pressed dome also gives a short downward pitch glide of the thump (about 1.5 : 1 over 30 ms) as the rubber collapses.
Envelope
attack 0.3–1 ms through a soft onset ramp (no click); the thump and modes fall exponentially; a smooth final fade ends the sound in about 0.15 s, with nothing sustained.
Variation
every render mistunes the modes by up to ±3 % and shifts the contact colour slightly through `rng`, so repeated taps are not identical. `tone` darkens or brightens the contact, `weight` balances thump against mid body, `damping` sets how fast the dome dies.
Parameters
Parameter
Range
Default
Unit
Controls
tone
0 – 1
0.4
—
Darkness to brightness of the fingertip contact
weight
0 – 1
0.5
—
Balance of the low thump against the mid body
damping
0 – 1
0.5
—
How quickly the dome dies away
pitch
260 – 650
400
Hz
Body pitch
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.