Soft Whoosh

A soft, airy whoosh that swells and fades smoothly; made for slide transitions

one-shot · 1.00 s · 0 downloads · 0 likes

0.00 / 1.00 sMP3 preview · default

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get 5TX1EPAA2Q@1 -o soft-whoosh.wav

Source: air displaced by a soft, slow-moving mass: pink noise is the turbulence; a second, high-passed layer at 3 kHz and above supplies the airy breath.
Body: two band-passes (Q ≈ 0.7, broad and smooth, no ringing): a body band sweeping 350 → 1800 → 500 Hz and an air band sweeping 1.5 → 5 → 2 kHz; a gentle low-pass at 9 kHz keeps it free of hiss.
Envelope: slow swell to a peak at about 50 % of the length (raised-cosine-like curve, ≈ 0.4 s attack) and a longer fade to silence; both ends start and end at exactly zero, so there are no clicks.
Variation: length, brightness, softness (air versus body balance) and travel across the stereo field; `rng` shifts the peak time by a few percent.

Parameters
Parameter	Range	Default	Unit	Controls
length	0.3 – 2.5	0.9	s	Length
brightness	0 – 1	0.5	—	Brightness
air	0 – 1	0.6	—	Air
travel	-1 – 1	0.6	—	Negative values travel right to left
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1