Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get 2X2DKP3WBJ@1 --preset distant-bulkhead -o space-station-hum.wav
How it's made
Source
continuously running corridor life-support motors transmit 72 Hz vibration through wall panels; six declining sine partials model rotor force, while filtered pink noise models turbulent duct flow.
Body
broad duct modes at 185 and 390 Hz (Q 1.4 and 1.1) colour the air; a 35-145 Hz noise bed fills the structure. Absorptive lining rolls the air off at 2.4-4.4 kHz, suggesting a sealed interior.
Machinery
a small pump's blade-passing whine sits near 936 Hz, with a weak second partial and diffuse bearing noise. Its pitch follows a smooth +/-0.7 Hz speed variation, never a dramatic sci-fi sweep.
Envelope
continuous sustain without starts, stops or discrete events. Motor amplitude moves only +/-2.5%; air breathes by +/-6% over 6 and 12 s cycles, whole periods within the default 12 s loop.
Space
centred structure tones and moderately spread independent air sources suggest nearby panels; two quiet 17/29 ms damped reflections colour the ducts without a long reverberant tail.
Variation
seeded phases vary motor alignment and breathing phase. Presets change motor speed, air, pump level and lining: sleeping deck, service passage, airlock approach and distant bulkhead.
Parameters
Parameter
Range
Default
Unit
Controls
speed
54 – 90
72
Hz
Motor speed
air
0 – 1
0.35
—
Ventilation
pump
0 – 1
0.35
—
Pump whine
lining
0 – 1
0.65
—
Acoustic lining
spread
0 – 1
0.45
—
Corridor width
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.