Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get ZMSERC8R6V@1 --preset standby -o starship-bridge-room-tone.wav
How it's made
Source
the steady room tone of a ship's command deck. Three continuous sources: a reactor/engine bed (low-passed brown noise plus two detuned sines near 48 and 96 Hz), ventilation air (pink noise through a broad band-pass around 600 Hz) and mains-style electrical hum (120 Hz and 240 Hz sines, very quiet).
Body
the engine pressure sits below 120 Hz; two sines detuned by ~0.3 Hz beat slowly, which reads as machinery breathing. The air band is narrowed and widened by a slow drift, like duct flow over panels.
Events
sparse console beeps, 0.8-3 s apart on average (poisson), each a soft 1.2-3.2 kHz sine with a 6 ms attack and 80-200 ms decay, sometimes followed by a second higher note; panned and low-passed so they sound distant. Their own sine tone is the only tonal event; nothing else is percussive.
Modulation
one slow drift (about 0.1 Hz) modulates engine level by +-15 %, a second one moves the air centre frequency; stereo noise is decorrelated left/right for width.
Variation
`rng` sets beep pitch, pan, spacing and the engine detune; presets move the balance between engine, air and beeps (idle watch, red alert standby, quiet night shift, busy bridge).
Parameters
Parameter
Range
Default
Unit
Controls
engine
0 – 1
0.55
—
Engine
air
0 – 1
0.45
—
Air hum
beeps
0 – 1
0.35
—
Beep density
brightness
0 – 1
0.4
—
Brightness
pitch
32 – 70
48
Hz
Engine pitch
spread
0 – 1
0.7
—
Width
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.