Sub Bass Stab

A deep synth bass stab: a pitch-dropping sub sine under gritty saturated saw overtones with a quick decay

one-shot · 0.80 s · 0 downloads · 0 likes

0.00 / 0.80 sMP3 preview · Gritty

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get 5CMVA29363@1 --preset gritty -o sub-bass-stab.wav

Source: a mono synth bass voice struck once. A sine sub-oscillator carries the fundamental (30–90 Hz); three slightly detuned band-limited saws (two at the fundamental, one an octave up) supply the harmonics.
Body: the saws pass through a tanh saturator (the grit) and then a low-pass whose cutoff starts open (0.4–3 kHz) and closes within ~0.25 s, so the attack is gritty and the tail collapses into a clean sub. The sub drops in pitch over the first ~40 ms, which gives the stab its punch.
Envelope: a 4 ms attack avoids a click, then an exponential decay (0.12–0.6 s) shapes the stab; a short release after the ring finishes the hit at about 1 s.
Variation: `rng` detunes the saws by a few cents and sets their start phase; grit, tone, decay and drop control the saturation drive, filter start, body length and pitch-drop depth. Presets move pitch, grit and decay.

Parameters
Parameter	Range	Default	Unit	Controls
pitch	30 – 90	49	Hz	Pitch
grit	0 – 1	0.5	—	Grit
tone	0 – 1	0.5	—	Tone
decay	0.12 – 0.6	0.32	s	Decay
drop	0 – 1	0.5	—	Pitch Drop
sub	0 – 1	0.7	—	Sub Level
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1