UIloop · 4.00 s
♥ 0↓ 0@sonicbricks
Tab Switch Click
A neat lateral click for switching tabs or segments: a faint slide brush into a clean, seated tick
one-shot · 0.22 s · 0 downloads · 0 likes
0.00 / 0.22 sSoft felt
Tweak
renders in the CLI · WAVChange parameters to build an exact command. Your agent runs it with sb and gets the WAV.
$ sb get ERX6D9V3Q0@1 --preset soft -o tab-switch-click.wav
How it's made
- Source
- a small plastic selector slides sideways one notch and seats in a detent. Two events: a faint 2–5 ms band-passed noise brush of the slide (about 1.5–4 kHz), then a 1–2 ms broadband contact as it seats.
- Body
- the seated cap rings in two damped modes (about 2.2 kHz and ×2.1, 18–45 ms); the housing adds a very short dry "tock" (260–420 Hz, under 25 ms) for weight. No cavity, no reverb.
- Envelope
- the brush leads by 12–20 ms and is a tenth of the click level; the contact attack is under 0.5 ms; everything is gone by about 0.1 s through a closing envelope.
- Space
- the brush travels across the field (about 0.35 to 0.1 of the pan range) and the click settles slightly off centre, so the lateral motion is a nudge, not a hard pan. `direction` flips the travel.
- Variation
- `rng` mistunes the modes by ±3 % and jitters the brush lead by ±1 ms. `brightness` opens the contact and the upper mode, `weight` raises the tock, `slide` sets brush level and lead, `direction` the side.
| Parameter | Range | Default | Unit | Controls |
|---|---|---|---|---|
| brightness | 0 – 1 | 0.5 | — | Brightness |
| weight | 0 – 1 | 0.35 | — | Weight |
| slide | 0 – 1 | 0.5 | — | Slide |
| direction | -1 – 1 | 1 | — | Side the selector travels toward (−1 left, 1 right) |
| pitch | 1500 – 3600 | 2200 | Hz | Cap pitch |
| decay | 0.015 – 0.05 | 0.03 | s | Decay |
| seed | int | 1 | — | Variation, reproducible |
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.
Revision history1
- r12026-10-24engine 1.0.1use('ERX6D9V3Q0@1')