Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get R7Z8ACMJZT@1 --preset heavy-rocker -o toggle-off.wav
How it's made
Source
a small rocker switch flipped off. Two mechanical contacts: the actuator snapping over its detent, then the lever landing against the housing stop. Each is a 1–2 ms high-passed noise tick.
Body
the plastic cap rings in two damped modes (≈ 1.4–3.2 kHz, ratio ≈ 2.3, 12–40 ms); the housing adds a short falling "thock" (sine gliding 520 → 260 Hz in 25 ms). The landing is lower, softer and duller.
Envelope
attack under 0.5 ms; the first tick is over in about 40 ms, the second starts at `gap` (60–110 ms) and rings slightly longer; the whole gesture ends near 0.25 s.
Variation
`rng` mistunes the modes by ±3 % and shifts the second tick's timing by ±1.5 ms. `drop` sets how far the second tick falls below the first; `tone` and `body` set brightness and weight.
Parameters
Parameter
Range
Default
Unit
Controls
tone
0 – 1
0.5
—
Brightness
body
0 – 1
0.45
—
Body
drop
0 – 1
0.5
—
How far the second tick falls below the first
gap
0.06 – 0.11
0.075
s
Time between the two ticks
pitch
1400 – 3200
2200
Hz
Cap pitch
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.