Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get RK7FESVMF3@1 --preset confirm -o upload-complete.wav
How it's made
Source
a clean electronic "send" gesture. A pure sine is swept upward (a rising pitch reads as data leaving the device), then lands on a soft struck-bell note that plays the resolving final tone.
Body
the glide is a sine plus a faint octave-up partial that fades in with pitch (spectral brightening); the landing note is a bell-like sine stack (1 : 2.01 : 3.02) whose upper partials decay 2-3x faster than the fundamental, so the attack is bright and the tail is pure.
Envelope
a 20 ms fade-in, a 0.12-0.4 s curved sweep that ducks as the final note starts near the end of the sweep, then an 8 ms strike and an exponential ring of 0.2-0.9 s; a short fade closes the sound.
Variation
`rng` detunes the landing partials by under 0.1 % and shifts the start pitch by about 1 %; macros set base pitch, glide time, resolving interval, ring and brightness. Presets change the interval and register: bright confirm, soft low, quick short and wide octave landing.
Parameters
Parameter
Range
Default
Unit
Controls
pitch
400 – 1400
784
Hz
Pitch
glide
0.12 – 0.4
0.22
s
Glide Time
interval
third · fourth · fifth · octave
fifth
—
Resolve Interval
ring
0.2 – 0.9
0.3
s
Ring
brightness
0 – 1
0.5
—
Brightness
range
0.35 – 0.8
0.6
—
Glide Start Ratio
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.