Warm Synth Pluck

A single warm synth pluck: detuned saws and a sub sine through a low-pass filter that sweeps closed

one-shot · 0.89 s · 0 downloads · 0 likes

0.00 / 0.89 sMP3 preview · Deep Bass

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get A8XK3JB89Q@1 --preset deep-bass -o warm-synth-pluck.wav

Source: a subtractive analog-style synth voice: two band-limited saws detuned by a few cents (chorus-like beating) plus a sine one octave down for weight, all plucked by a gate that closes immediately.
Body: a resonant low-pass filter (Q 1.2, no harsh peak) whose cutoff sweeps from a few harmonics above the fundamental down towards the fundamental; the bright onset collapses into a round, warm tail.
Envelope: a 6 ms soft attack avoids a click, then an exponential amplitude decay of 0.2–0.7 s; the filter envelope falls faster than the amplitude (about 60 %), so brightness leaves before the level does.
Variation: `rng` offsets the detune and start phase slightly per render; macros set pitch, filter opening, decay and sub weight; presets move between a deep bass pluck, a glassy lead and a soft pad-like note.

Parameters
Parameter	Range	Default	Unit	Controls
pitch	55 – 880	220	Hz	Pitch
decay	0.15 – 0.8	0.55	s	Decay
brightness	0 – 1	0.5	—	Brightness
sweep	0 – 1	0.6	—	Filter Sweep
sub	0 – 1	0.4	—	Sub Weight
detune	0 – 25	9	cents	Detune
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1