Water Drop Notify

A clean water droplet with a fast upward chirp and a short resonant bloop, for minimal app notifications

one-shot · 0.40 s · 0 downloads · 0 likes

0.00 / 0.40 sMP3 preview · Double bubble

Preset

Show spectrogram

Free for commercial use. No attribution needed.

Tweak

renders in the CLI · WAV

Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.

Command

$ sb get 8S8BXV2MXN@1 --preset double -o water-drop-notify.wav

Source: a single droplet landing in still water. The "bloop" is the air bubble the drop traps: a damped sine at the Minnaert frequency whose pitch climbs quickly as the bubble is pulled toward the surface.
Body: fundamental plus a faint 2x partial that dies sooner (the bright start of the bloop), and a second, smaller bubble about 70 ms later at a slightly higher pitch, which gives the short, resonant tail.
Transient: a 3 ms band-limited noise tick for the impact, kept soft so it never clicks.
Envelope: 1.5 ms fade-in on the tone (no click), exponential decay of 60-220 ms, a closing fade at 0.3-0.4 s.
Variation: `rng` shifts the pitch by +-2 % and the secondary bubble timing by a few milliseconds.

Parameters
Parameter	Range	Default	Unit	Controls
pitch	400 – 1400	700	Hz	Pitch
chirp	0 – 1	0.55	—	Chirp
decay	0.06 – 0.22	0.14	s	Ring
echo	0 – 1	0.4	—	Second bubble
splash	0 – 1	0.3	—	Splash
seed	int	1	—	Variation, reproducible

The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.

Revision history1