Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get QJM16SK49Y@1 --preset far -o zoom-out.wav
How it's made
Source
air rushing past a retreating viewpoint, modelled as pink noise high-passed at 150 Hz; a faint tonal glide (two detuned sines, 900 -> 380 Hz) adds the "pull back" pitch cue of a UI gesture.
Body
a band-pass (Q ~ 1.1) sweeps down from 2-5 kHz to about 450 Hz while a low-pass closes in step, so the spectrum visibly darkens as the view recedes (the closing filter).
Settle
a soft 110 Hz sine bump (about 30 ms) lands when the view comes to rest, scaled by `tone`.
Envelope
12 ms soft attack, peak at about 25 % of the length, then an eased fall to silence; the tone layer fades earlier than the air so the tail is pure soft breath.
Variation
`rng` shifts the peak time by a few percent and the tone tuning by +-2 %; `length`, `brightness`, `tone` and `depth` (sweep range) are exposed; the image drifts from slightly off-centre to the middle.
Parameters
Parameter
Range
Default
Unit
Controls
length
0.15 – 0.7
0.3
s
Length
brightness
0 – 1
0.5
—
Brightness
tone
0 – 1
0.55
—
Tone
depth
0 – 1
0.6
—
How far the sweep falls
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.