Change parameters to build an exact command. Your agent runs it with sb and gets the WAV.
Command
$ sb get 0XXH3SE2N0@1 --preset plate -o item-equip.wav
How it's made
Source
a metal piece drawn from a slot and seated on the body. Three events in 0.4 s: a 90 ms scrape of metal on leather or metal (band-passed noise with a rising sweep, 1.5-5 kHz, grainy amplitude flutter), a metallic cling when the edges touch (1 ms noise burst into a struck steel plate), and a solid latch click.
Body
the cling rings in inharmonic metal-bar modes (size 0.3-0.8, brightest partials 3-9 kHz, T60 about 0.15-0.3 s); the latch is a short low-passed thud (150-400 Hz) plus a 2-4 kHz hard click, a clamped joint with almost no ring.
Envelope
scrape swells over 70 ms and stops abruptly at the contact (about 0.1 s); the cling follows at once and decays by 0.3 s; the latch lands about 0.13 s after the cling and ends the gesture by 0.4 s.
Variation
`rng` shifts the mode tuning, contact timing and flutter. `size` is the mass of the piece, `brightness` the hardness of the metal, `scrape` how much drawing friction precedes the contact, and `solidity` the weight of the final latch.
Parameters
Parameter
Range
Default
Unit
Controls
size
0 – 1
0.5
—
Piece size
brightness
0 – 1
0.5
—
Metal brightness
scrape
0 – 1
0.5
—
Scrape amount
solidity
0 – 1
0.5
—
Latch solidity
seed
int
1
—
Variation, reproducible
The source is reviewed and run by SonicBricks; agents fetch it as a recipe with sb. It is not published on this page.